I have AiMesh active with one main router and two nodes. Something about the wonderful world of Windows.Trying to figure out what is going on.hundreds of these occurring. I've got one PC that just won't connect to some of my FCs.even when the same drivers I use (successfully) on other PCs are installed. BF should show it's connected in DFU mode and you can do the manual firmware install (don't click the CONNECT button to download). Connect the FC USB to the PC while holding the boot button in.ĥ. Start BETAFLIGHT (I've never tried using iNav. The ImpulseRC Driver Fixer should then see and load the proper driverģ. Connect the FC USB to the PC WHILE holding the boot button in. Without watching the linked video.did you:Ģ. I tried ImpulseRX driver fixer but that doesn't help either. Once it jumped to CLI mode and I put it in dfu mode but after that the board would not connect. I used this video Step By Step Guide | Arduplane/Chibios On Matek F405 Wing Board | Full Configuration & OSD | Omnibusĭownloaded the hex file from the one with BL.Ĭonnected the board with my computer, opened Inav configurator, I could not connect to the board first I get "serial port openend with ID9" after that I get "no configuration received within 10 seconds, communication failed" I just bought a Matek F405-wing, I wanted to flash the board with arduplane.
0 kommentar(er)
